Tashkent city

45-metre aerial platform in Sergeli

For exterior work on newer buildings, show the access surface and the exact facade point. This affects lift placement. Before facade work at a new block, confirm whether the surface beside the wall is finished. For a roof work point, also show the parapet and the distance from it to the equipment or repair area.

Call us Message on Telegram

45 m

01Local landmark

Sergeli District

Sergeli is a southern district of Tashkent with active residential development, served by the Sergeli metro line.

South of the city on the Sergeli line — write the Sergeli estate number and nearest station.

Area illustration: Sergeli District — Sergeli District

0245-metre aerial platform

Jobs at your site

Facade access

For joint sealing, local repairs or facade inspection, mark the work area on a full-building photo. Height and horizontal distance from the vehicle are assessed together.

Roof edges, eaves and gutters

Roof-edge access requires eaves height and the proposed parking position. For a point behind a parapet or further onto the roof, mark its setback from the edge and any obstacles.

Workshop or warehouse cladding

For local facade-panel replacement, show the panel dimensions and fixing position. Suitability depends on access to the joint, vehicle position and permitted platform load.

03Before booking

Site preparation

Show the entire work side and mark the required facade section.
Take a side photo showing both the roof and proposed vehicle position.
Confirm panel dimensions, tools and the planned working team.

What to send with your enquiry

Send the address, work height and photos of the facade, access route and lift parking space.

Message on Telegram

04Sergeli District

Questions before booking

Is the floor number enough?

Give the height in metres and mark the point on a photo. Floor count does not show vehicle setback, canopies or other obstacles and cannot establish reach on its own.

Can the platform reach equipment further onto the roof?

That depends on height, edge setback, parapet and vehicle position. A working height of up to 45 m does not imply the same horizontal reach.

Can the whole workshop be covered from one position?

Not necessarily. Facade length and distances to end points are assessed against boom geometry. Show access along the building so possible repositioning can be discussed.

Sergeli District